Trojan Gold 12
Dimensions - 1.2m2 base and standard 2m tall
Framework - 19mm diameter powder coated metal frame, full click system
Cloth - 600D Mylar lined Oxford cloth.
Exhaust ventilation port - 1 x 254mm (accepts 10" Standard duct or 8" Insulated) located at the back of the tent roof.
Intake ventilations - 2 x 204mm (accepts 8" standard duct or 6" Insulated) located on either side of the tent at the lower front.
Air Cooled ventilation ports - 2 x 254mm (accepts 10" Standard duct or 8" Insulated)
High level cable entry ports for lighting, fans and pumps.
Lighting - We recommend a 400W/600W metal halide for vegative stages and a 600W HPS for flowering. Which light you choose will be dependent on the ambient temperature of the incoming air. The wattage of lighting will ultimately dictate your ventilation requirements.
400W = Low power use in high temp environments or vegetative stages
600W = our standard light recommendation
1000W = Enhanced light recommendation (air cooled preferably)
Ventilation 400W light = 4" RVK A1/VK (winter) - 5" RVK L1/VK (summer)
600W light = 4" RVK A1/VK (winter) - 6" RVK A1/VK (summer)
1000W light = 6" RVK A1/VK (winter) - 8" RVK A1/VK (summer)
The use of air cooled lights will reduce the exhaust ventilation requirements, but will require a separate fan for the reflectors.
We recommend the use of a thermostatically controlled fan speed controller to maintain your temperatures within the desired range.
Intake fans - The flow rates should be approximately 30-50% less than the exhaust fan(s) flow rate. This is to allow for the restrictions caused by carbon filters and to ensure negative pressure, when correctly set up your Trojan tent should be sucking in slightly. When using intake fans always have a passive intake (ducting without a fan) this will ensure that the tent can breathe and that you aren't causing too much restriction on the intake.